福建武夷山提高小型压路机振动压路机工作效率

使用微信扫描二维码分享朋友圈，成交更快更简单！

如何提高福建武夷山天通小型压路机振动压路机工作效率

由于之前有多台压路机变速箱漏油故障成功维修案例，总结经验分析导致这一故障出现的常见原因有：

1 油封、O型圈磨损（硬化导致失去弹性从而引起漏油）。

2 变速轴轴颈磨损以及加工误差导致漏油。

3 放油塞松动、变速箱箱体有裂缝。

4 变速箱排气螺塞处漏油（油箱内润滑油太多）

5 排气螺塞被异物堵塞。

每天做到这样保养天通小型压路机：

1.压路机检查有无油、水、气的渗漏及机件过热现象；

2.压路机检查柴油机机油、冷却液和液压油液位；

3.压路机检查轮胎气压及损坏情况；

4.压路机检查仪表和灯光；

5.各铰接点压注黄油。

注：路基工程施工中，压路机安全作业要点有哪些：压路机启动时，要特别注意前后左右的情况，在周围无人和 障碍物时方可启动。压路机碾压傍山道路时，由里侧向外侧碾压。压路机在 填方路堤边缘作业时，要注意与边缘保持安全距离。特别注意：压路机不能上陡坡。两台以上压路机同时作业，其前后间距不得小于 3 米，在坡 道上纵队行驶时，其间距不得小于 20 米。

How to improve the working efficiency and maintenance of the roller?

Due to the successful maintenance cases of oil leakage faults in a number of roller gearboxes, the common reasons for this failure are summarized as follows:

1 oil seal and O type ring wear (hardening causes the loss of elasticity to cause oil leakage).

2 the wear of the journal and the machining error caused the oil leakage.

3 the loosening of the oil discharge plug and the gearbox have cracks.

The oil exhaust plug office 4 gearbox (too much oil in the oil tank)

5 exhaust plug blockage.

Every day to do so to maintain a small pressure road machine:

1. rollers check the leakage of oil, water and gas and the overheating of the machine parts.

2. rollers check diesel engine oil, coolant and hydraulic oil level.

3. rollers check the tire pressure and damage.

4. the instrument and light of the press;

5. the hinge points are pressed with butter.

Note: what are the key points of road roller safety operation during construction of roadbed? Special attention should be paid to the situation of the front and rear sides when the roller is started, so that it can be activated when there are no people around or obstacles. When a road roller compacts a mountain road, it must be rolled by the lateral side of the road. When the roller is working on the edge of the embankment, we should keep a safe distance from the edge. Special attention: the roller can't go up the steep slope. At the same time, two or more rollers can not be less than 3 meters, and the distance should not be less than 20 meters on the slope on the ramp.